Chapter 10 Interface

Table 57 Network > Interface > Bridge (continued)

LABEL

DESCRIPTION

IP Address

This field displays the current IP address of the interface. If the IP address is

 

0.0.0.0, the interface does not have an IP address yet.

 

This screen also shows whether the IP address is a static IP address (STATIC)

 

or dynamically assigned (DHCP). IP addresses are always static in virtual

 

interfaces.

 

 

Member

This field displays the Ethernet interfaces and VLAN interfaces in the bridge

 

interface. It is blank for virtual interfaces.

 

 

Add icon

This column lets you create, edit, remove, activate, and deactivate interfaces.

 

To create a bridge interface, click the Add icon at the top of the column. The

 

Bridge Add/Edit screen appears.

 

To create a virtual interface, click the Add icon next to the corresponding bridge

 

interface. The Virtual Interface Add/Edit screen appears. See Section 10.8 on

 

page 217.

 

To edit an interface, click the Edit icon next to it. The Bridge Add/Edit screen

 

or Virtual Interface Add/Edit screen appears accordingly.

 

To remove an interface, click the Remove icon next to it. The ZyWALL confirms

 

you want to remove it before doing so.

 

To activate or deactivate an interface, click the Active icon next to it. Make sure

 

you click Apply to save and apply the change.

Apply

Click Apply to save your changes back to the ZyWALL.

 

 

Reset

Click Reset to begin configuring this screen afresh.

 

 

10.5.4 Bridge Add/Edit

This screen lets you configure IP address assignment, interface bandwidth parameters, DHCP settings, and ping check for each bridge interface. To access this screen, click the Add icon at the top of the Add column in the Bridge Summary screen, or click an Edit icon in the Bridge Summary screen. The following screen appears.

206

 

ZyWALL USG 1000 User’s Guide