Chapter 44 Service Control
44.10.3 Configuring SNMPTo change your ZyWALL’s SNMP settings, click System > SNMP tab. The screen appears as shown. Use this screen to configure your SNMP settings, including from which zones SNMP can be used to access the ZyWALL. You can also specify from which IP addresses the access can come.
Figure 454 System > SNMP
The following table describes the labels in this screen.
Table 212 System > SNMP
LABEL | DESCRIPTION |
Enable | Select the check box to allow or disallow the computer with the IP address that |
| matches the IP address(es) in the Service Control table to access the ZyWALL |
| using this service. |
|
|
Server Port | You may change the server port number for a service if needed, however you must |
| use the same port number in order to use that service for remote management. |
|
|
Get Community | Enter the Get Community, which is the password for the incoming Get and |
| GetNext requests from the management station. The default is public and allows all |
| requests. |
|
|
Set Community | Enter the Set community, which is the password for incoming Set requests from |
| the management station. The default is private and allows all requests. |
|
|
Trap |
|
|
|
Community | Type the trap community, which is the password sent with each trap to the SNMP |
| manager. The default is public and allows all requests. |
|
|
Destination | Type the IP address of the station to send your SNMP traps to. |
|
|
Service Control | This specifies from which computers you can access which ZyWALL zones. |
|
|
# | This the index number of the service control rule. |
|
|
Zone | This is the zone on the ZyWALL the user is allowed or denied to access. |
|
|
Address | This is the object name of the IP address(es) with which the computer is allowed or |
| denied to access. |
|
|
Action | This displays whether the computer with the IP address specified above can access |
| the ZyWALL zone(s) configured in the Zone field (Accept) or not (Deny). |
|
|
608 |
| |
ZyWALL USG 1000 User’s Guide |
| |
|
|
|