Chapter 4 Wizard Setup

4.8.1 VPN Express Wizard - Policy Setting

The Policy Setting specifies which devices can use the VPN tunnel. Local and remote IP addresses must be static.

Local Policy (IP/Mask): Type the IP address of a computer on your network. You can also specify a subnet. This must match the remote IP address configured on the peer IPSec device.

Remote Policy (IP/Mask): Type the IP address of a computer behind the peer IPSec device. You can also specify a subnet. This must match the local IP address configured on the peer IPSec device.

Figure 36 VPN Express Wizard: Step 4

The following table describes the labels in this screen.

Table 17 VPN Express Wizard: Step 4

LABEL

DESCRIPTION

Summary

 

 

 

Name

This is the name of the VPN connection (and VPN gateway).

 

 

Secure

This is the WAN IP address or domain name of the remote IPSec router. If this field

Gateway

displays 0.0.0.0, only the remote IPSec router can initiate the VPN connection.

 

 

Pre-Shared

This is a pre-shared key identifying a communicating party during a phase 1 IKE

Key

negotiation.

 

 

Local Policy

This is a (static) IP address and Subnet Mask on the LAN behind your ZyWALL.

 

 

Remote

This is a (static) IP address and Subnet Mask on the network behind the remote

Policy

IPSec router.

 

 

 

99

ZyWALL USG 1000 User’s Guide