ZyXEL Communications ZyWALL 1000 manual 216

Chapter 10 Interface

Figure 141 Network > Interface > Auxiliary

Each field is described in the table below.

Table 61 Network > Interface > Auxiliary

LABEL	DESCRIPTION
Auxiliary Interface
Properties
Enable	Select this to turn on the auxiliary dial up interface. The interface does not dial
	out, however, unless it is part of a trunk and load-balancing conditions are
	satisfied.
Description	Enter a description of this interface. It is not used elsewhere. You can use
	alphanumeric and ()+/:=?!*#@$_%- characters, and it can be up to 60
	characters long.
Port Speed	Select the speed of the connection between the ZyWALL and external
	computer.
Dialing Type	Tone - select this if the telephone uses tone-based dialing.
	Pulse - select this if the telephone uses pulse-based dialing.
Initial String	Enter the AT command string to initialize the external modem. ATZ is the most
	common string, but you should check the manual for the external modem for
	additional commands.
Auxiliary
Configuration
Phone Number	Enter the phone number to dial here. You can use 1-20 numbers, commas (,),
	or plus signs (+). Use a comma to pause during dialing. Use a plus sign to tell
	the external modem to make an international call.
User Name	Enter the user name required for authentication.
Password	Enter the password required for authentication.
Retype to	Enter the password again to make sure you have not typed it incorrectly.
confirm

216
	ZyWALL USG 1000 User’s Guide