Chapter 27 Application Patrol
Figure 299 Application Patrol Bandwidth Management Example
SIP: Any to WAN | SIP: WAN to Any | |
Outbound: 200 Kbps | Outbound: 200 Kbps | |
Inbound: 200 Kbps | Inbound: 200 Kbps | |
Priority: 1 | Priority: 1 | |
Max. B. U. | Max. B. U. | |
HTTP: Any to WAN |
| |
Outbound: 100 Kbps |
| |
Inbound: 500 Kbps |
| |
Priority: 2 |
| |
Max. B. U. |
| |
FTP: WAN to DMZ | ADSL | |
Up: 1 Mbps | ||
Outbound: 100 Kbps | ||
Down 8 Mbps | ||
Inbound: 300 Kbps | ||
Priority: 3 |
| |
No Max. B. U. |
| |
| FTP: LAN to DMZ | |
| Outbound: 50 Mbps | |
| Inbound: 50 Mbps | |
| Priority: 4 | |
| No Max. B. U. |
Use the interface screens to set the WAN zone interface’s upstream bandwidth to be equal to (or slightly less than) what the connected device can support. This example uses 1000 Kbps.
27.5.2SIP Any to WAN Bandwidth Management Example•Manage SIP traffic going to the WAN zone from a VIP user on the LAN or DMZ.
•Outbound traffic (to the WAN from the LAN and DMZ) is limited to 200 kbps. The ZyWALL applies this limit before sending the traffic to the WAN.
•Inbound traffic (to the LAN and DMZ from the WAN) is also limited to 200 kbps. The ZyWALL applies this limit before sending the traffic to LAN or DMZ.
•Highest priority (1). Set policies for other applications to lower priorities so the SIP traffic always gets the best treatment.
•Enable maximize bandwidth usage so the SIP traffic can borrow unused bandwidth.
| 385 |
ZyWALL USG 1000 User’s Guide | |
|
|