Agilent Technologies 8935 series e6380a manual Ofs Trnsfer, Output Port, Phase/div

CDMA Measurements - Screens and Control Fields

Control Fields for CDMA Measurements

Ofs Trnsfer

IS-95 only. This field transfers the time offset value from the time offset measurement (displayed in TmOfs) to the Time Offset field automatically. Before selecting Ofs Trnsfer, you must make at least one of the following code domain measurements:

•Power

•Timing

•Phase

Operating Considerations

When using this command programmatically, be sure a value for Tm Ofs has been obtained from a power, timing, or phase measurement. (One method of ensuring the measurement has been completed would be to send an GPIB command to query the results of the Tm Ofs field before sending the transfer command).

Screens on which this field is present

COD DOM (Code Domain Analyzer): FP setup controls menu

Output Port

This field selects the output port for the signal from the Test Set’s RF and CDMA generators.

RF Out selects the RF IN/OUT connector.

Dupl selects the DUPLEX OUT connector.

Screens on which this field is present

CDMA GENERATOR

Phase/div

This field sets the display resolution for the code domain phase measurement: 1, 2, 5, 10, 20, or 50 milliradians (mrad). This field is displayed on the CODE DOM screen’s Marker menu when the Measurement field is set to Phase.

Screens on which this field is present

CODE DOM (Code Domain Analyzer, IS-95 only): marker controls menu

164 Chapter 5

C:\Spk\Ref\RefGuideRevE\CdmascrnE2.fm