Signaling Encoder and Decoder - Screens and Control Fields

Control Fields for the Signaling Encoder and Decoder

Send Mode

This field selects the mode used when Send is selected to output the message.

Single outputs the entire message once.

Burst outputs the Message the number of times specified in the

Bursts field.

Cont causes the message to be output continuously until Stop is selected.

Step is not used in the AMPS-TACS mode.

Screens Where Field is Present

SIGNALING ENCODER (Modes: AMPS-TACS, NAMP-NTAC, DTMF)

Sine Units

This field specifies whether the signal’s output is in units of rms or peak. This field is only present when the AFGen2 To field is set to Audio Out.

Screens Where Field is Present

SIGNALING ENCODER (Modes: Func Gen)

Single/Cont

This field specifies how long you want the analyzer to decode incoming signals:

Single tells the analyzer to display the information received during one Gate Time. Measurements are displayed until Arm Meas is selected again.

Cont is used to automatically re-arm the analyzer and display the measurements on a continual basis until Single is selected. Previous measurement results are over-written by subsequent measurements.

Operating Considerations

To dis-arm the decoder in single mode, select the Stop Meas field. The Stop Meas function is disabled when Cont is selected.

Screens Where Field is Present

SIGNALING DECODER (All Modes)

Chapter 8

275

Page 271
Image 271
Agilent Technologies 8935 series e6380a manual Send Mode, Sine Units, Single/Cont, Signaling Encoder Modes Func Gen