Agilent Technologies 8935 series e6380a manual Cable Fault Setups

Overview of theTest Set’s Built-In Tools

Using the RF Tools Program

Figure 4-17 Cable Fault Setups

Calibration Setup

	AUDIO OUT	AUDIO IN		BASEBAND OUT		DATA
		HI		LO
				I	Q	IN
ANALOG	SCOPE	EXT SCOPE	VIDEO
MODULATION	MONITOR	TRIG IN	OUT
IN	OUT

8935

ANT IN	DUPLEX OUT	16X		FRAME	EVEN	TRIGGER
		CHIP CLOCK CHIP CLOCK							RF IN/OUT
		19.6608	1.2288	CLOCK	SECOND	QUALIFIER	10 MHz	EXT
		MHz OUT	MHz OUT	OUT	SYNC IN	IN	REF OUT	REF IN

Measurement Setup

	AUDIO OUT	AUDIO IN		BASEBAND OUT		DATA
		HI		LO
				I	Q	IN
ANALOG	SCOPE	EXT SCOPE	VIDEO
MODULATION	MONITOR	TRIG IN	OUT
IN	OUT

8935

ANT IN	DUPLEX OUT	16X		FRAME	EVEN	TRIGGER
		CHIP CLOCK CHIP CLOCK							RF IN/OUT
		19.6608	1.2288	CLOCK	SECOND	QUALIFIER	10 MHz	EXT
		MHz OUT	MHz OUT	OUT	SYNC IN	IN	REF OUT	REF IN

ANT IN DUPLEX OUT ANT IN DUPLEX OUT

Resistive Splitter Resistive Splitter

OUT OUT OUT OUT

IN IN

50 Ohm

Termination

Attach device to

be tested.

cablef.eps

8.A setup screen appears with a diagram of the necessary connections (see Figure 4-17). It is very important that the power divider is a 2-way resistive device. Press k1 (Proceed) or the knob after the hardware is connected.

9.After the Test Set has finished calibrating, a second diagram appears on the screen. Connect the cable to be tested. Press k1 (Proceed) or the knob to continue.

10.The plot screen appears similar to Figure 4-18 on page 101. To save the plot to a PC card, press k4 (Save Plot) and use the knob to enter a filename. Press k5 (Scr Dump) to send the image to a printer or to the BTS Laptop Utility. Directions will appear at the top of the screen. Press PRINT and allow the image to print to the connected device. Then, press PAUSE/CONTINUE. Press k1 (Proceed) when you are ready to continue.

100 Chapter 4

C:\Spk\Ref\RefGuideRevE\Tools.fm