AT-S79 Management Software User’s Guide
3.Type P to select Port No.
The following prompt is displayed:
Enter port number>
4.Enter the number of the port on the switch you want to configure. You can configure only one port at a time.
The Port Based Access Control Configuration Menu is updated with the current settings of the selected port.
5.Configure the 802.1x settings for the port. A change to a parameter takes affect immediately on the port. The settings are described here:
NAS ID.
This parameter assigns an 802.1x identifier to the switch that applies to all ports. The NAS ID can be up to sixteen characters. Valid characters are 0 to 9, a to z, and A to Z. Spaces are allowed. Specifying an NAS ID is optional.
Port Status.
Displays the current 802.1 status of the port as either authorized or unauthorized. This is not an adjustable parameter.
Port Control.
Sets the 802.1x port control setting. The possible settings are:
A (Auto) - Enables 802.1x
U
F
Transmission Period.
Sets the number of seconds that the switch waits for a response to an
Section I: Using the Menus Interface | 137 |