AT-S79 Management Software User’s Guide

Configuring the RADIUS Client

To configure the RADIUS client, perform the following procedure:

1.From the Main Menu, type B to select Basic Switch Configuration. The Basic Switch Configuration Menu is shown in Figure 4 on page 30.

2.From the Basic Switch Configuration Menu, type U to select User Interface Configuration.

The User Interface Configuration Menu is shown in Figure 7 on page 36.

3.Type R to select RADIUS Server Configuration.

The RADIUS Server Configuration Menu is shown in Figure 37.

AT-GS950/16 Local Management System

Basic Switch Configuration -> RADIUS Server Configuration Menu

Server IP Address

:

0.0.0.0

Shared Se[c]ret

:

 

Response Time

:

10 seconds

Maximum Retransmission :

3

-----------------------

 

<COMMAND> -----------------------------

Set Server [I]P

 

 

Set Shared Se[c]ret

 

 

Set [R]esponse Time

 

 

Set [M]ax Retransmission

 

[Q]uit to previous menu

 

 

Command>

Figure 37. RADIUS Server Configuration Menu

4.Type I to select Set Server IP. The following prompt is displayed:

Enter IP address for RADIUS server>

5.Type the IP address of the RADIUS server and press Enter.

6.Type C to select Shared Secret. The following prompt is displayed:

Enter secret string for server>

Section I: Using the Menus Interface

143

Page 143
Image 143
Allied Telesis AT-S79 manual Configuring the Radius Client, Type R to select Radius Server Configuration