
Chapter 9: Rapid Spanning Tree Protocol (RSTP)
Configuring STP Compatibility
Choosing an RSTP protocol version allows you to determine if the switch ports will operate in
To configure the STP compatibility, perform the following procedure:
1.From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 4 on page 30.
2.From the Basic Switch Configuration Menu, type S to select Rapid Spanning Tree Configuration.
The Rapid Spanning Tree Configuration Menu is shown in Figure 30 on page 115.
3.Type V to select Set RSTP Protocol Version. The following prompt is displayed:
Set RSTP protocol version (S/R)>
4.Type S to make the ports
120 | Section I: Using the Menus Interface |