Allied Telesis AT-S79 manual Rstp Advanced Port Configuration menu is shown in Figure

Chapter 9: Rapid Spanning Tree Protocol (RSTP)

The RSTP Advanced Port Configuration menu is shown in Figure 31.

AT-GS950/16 Local Management System

Rapid Spanning Tree Configuration -> RSTP Advanced Port Configuration

Port	Trunk	Link	State	Role	Admin/OperEdge	Admin/OperPtoP	Migrat
----	-----	----	----------	-------------------------------------------
1	---	Down	Forwarding	Disabled	False/False	Auto/False	Init.
2	---	Down	Forwarding	Disabled	False/False	Auto/False	Init.
3	---	Down	Forwarding	Disabled	False/False	Auto/False	Init.
4	---	Down	Forwarding	Disabled	False/False	Auto/False	Init.
5	---	Down	Forwarding	Disabled	False/False	Auto/False	Init.
6	---	Down	Forwarding	Disabled	False/False	Auto/False	Init.
7	---	Down	Forwarding	Disabled	False/False	Auto/False	Init.
8	---	Down	Forwarding	Disabled	False/False	Auto/False	Init.
9	---	Down	Forwarding	Disabled	False/False	Auto/False	Init.
10	---	Down	Forwarding	Disabled	False/False	Auto/False	Init.
11	---	Down	Forwarding	Disabled	False/False	Auto/False	Init.
12	---	Down	Forwarding	Disabled	False/False	Auto/False	Init.

-------------------------------	<COMMAND> ---------------------------------
[N]ext Page	Set Port P-[t]o-P Status
[P]revious Page	Restart Port [M]igration
Set Port [E]dge Status	[Q]uit to previous menu
Command>

Figure 32. RSTP Advanced Port Configuration Menu

4.Type E to select Edge Status. The following prompt is displayed: The following prompt is displayed:

Select port number to be changed>

Port number is in range from 1 to 9, 0 to set all ports

5.Enter the number of the port you want to change, or type 0 (zero) to apply the settings to all ports on the switch.

The following prompt is displayed:

Set edge port for port n >(T/F)>

This parameter defines whether the port is functioning as an edge port. The possible settings are True and False. For an explanation of this parameter, refer to “Point-to-Point and Edge Ports” on page 111.

6.Enter T for True or F for False to change the Admin/OperEdge status.

7.Type P to select P-to-P Status.

124 Section I: Using the Menus Interface