Chapter 20: Quality of Service (QoS)
Mapping CoS Priorities to Egress Queues
This procedure explains how to change the default mappings of CoS priorities to egress priority queues, as shown in Table 2 on page 97. This is set at the switch level. You cannot set this at the
To change the default mappings of CoS priorities to egress priority queues or to enable or disable QoS, perform the following procedure:
1.From the Advanced Config menu, select QoS Config and then select QoS Config.
The QoS Configuration page is shown in Figure 61.
Figure 61. QoS Configuration Page
2.To enable or disable QoS, select Enable or Disable from the QoS Status pull-down menu. The default is disabled.
3.To change the egress priority queue assignment of an 802.1p priority class, click the dialog circle of the queue for the corresponding priority. For example, to direct all tagged traffic with a priority of 4 to egress queue 3 on the ports, you would click the dialog circle for queue 3 in the priority 4 row.
4.Click Apply.
210 | Section II: Using the Web Browser Interface |
