AT-S79 Management Software User’s Guide

3.Type I to select Set Target IP Address. The following prompt is displayed:

Enter new target IP address>

4.Type the IP address of the node you want the switch to ping and press Enter.

5.Type N to select Set Number of Requests. The following prompt is displayed:

Enter new number of requests>

6.Enter the number of ping requests you want the switch to perform. The range is 1 to 10. The default is 10.

7.Type T to select Set Timeout Value. The following prompt is displayed:

Enter new timeout value>

8.Enter the length of time in seconds the switch is to wait for a response before assuming that a ping has failed. The range is 1 to 5 seconds. The default is 3 seconds.

9.Type E to select Execute Ping. The following prompt is displayed:

Execute ping or Clean ping data (E/C)>

10.Type E to execute the ping or C to clear previous ping data before performing this ping.

Section I: Using the Menus Interface

45

Page 45
Image 45
Allied Telesis AT-S79 manual Enter new target IP address