Allied Telesis AT-S79 manual Configuring 802.1x Port-based Network Access Control, Nas Id

Chapter 10: 802.1x Port-based Network Access Control

Configuring 802.1x Port-based Network Access Control

To configure 802.1x port-based network access control, perform the following procedure:

1.From the Main Menu, type A to select Advanced Switch Configuration.

The Advanced Switch Configuration Menu is shown in Figure 14 on page 59.

2.From the Advanced Switch Configuration Menu, type X to select 802.1x Port Based Access Control Configuration.

The Port Based Access Control Configuration Menu is shown in Figure 36.

AT-GS950/16 Local Management System

Advanced Switch Configuration -> Port Based Access Control Configuration Menu

NAS ID	: Nas1
Port No	: 1
Port Status	: Authorized
Port Control	: Force Authorized
Transmission Period	: 30	seconds
Supplicant Timeout	: 30	seconds
Server Timeout	: 30	seconds
Maximum Request	: 2
Quiet Period	: 60	seconds
Re-authentication Period	: 3600	seconds
Re-authentication Status	: Disabled
-----------------------	<COMMAND>	------------------------------------
[N]AS ID	Server Time[o]ut		[I]nitialize
[P]ort No	[M]aximum Request		[R]e-auth Initialize
Port [C]ontrol	Q[u]iet Period		[Q]uit to previous Page
[T]ransmission Period	R[e]-auth Period
Supp[l]icant Timeout	Re-[a]uth Status

Command>

Figure 36. Port Based Access Control Configuration Menu

136 Section I: Using the Menus Interface