Configuring the
Advanced RSTP
Port Settings
AT-S79 Management Software User’s Guide
Select port number to be changed>
Port number is in range from 1 to 9, 0 to set all ports
This parameter enables or disables RSTP on a specified port or a group of ports in a trunk.
11.Enter the number of the port you want to change, or type 0 (zero) to apply the settings to all ports on the switch.
The following prompt is displayed:
Enable or Disable STP for port n (E/D)>
12.Type E to enable or D to disable STP on the port.
To configure the advanced RSTP port settings, perform the following procedure:
1.From the Main Menu, type B to select Basic Switch Configuration. The Basic Switch Configuration Menu is shown in Figure 4 on page 30.
2.From the Basic Switch Configuration Menu, type S to select Rapid Spanning Tree Configuration.
The Rapid Spanning Tree Configuration Menu is shown in Figure 30 on page 115.
3.From the Rapid Spanning Tree Configuration Menu, type A to select RSTP Advanced Port Configuration.
Section I: Using the Menus Interface | 123 |
