Chapter 2: Getting Started with the Menus Interface

Starting a Local Management Session

You establish a local management session with the switch by connecting a terminal or personal computer with a terminal emulation program to the the RS-232 console port on the front panel of the switch.

Note

You do not need to assign an IP address to the switch to manage the unit from a local management session.

To start a local management session, perform the following procedure:

1.Connect one end of the management cable included with the switch to the console port on the switch, as shown in Figure 1.

23

CONSOLE

 

 

24

Figure 1. Connecting the Management Cable to the Console Port

2.Connect the other end of the cable to the RS-232 port on a terminal or PC with a terminal emulator program.

3.Configure the terminal or terminal emulator program as follows:

ˆBaud per second: 9600

ˆData bits: 8

ˆStop bits: 1

ˆFlow control: None

Note

These settings are for a DEC VT100 or ANSI terminal, or an equivalent terminal emulation program. They cannot be changed.

24

Section I: Using the Menus Interface

Page 24
Image 24
Allied Telesis AT-S79 manual Starting a Local Management Session