AT-S79 Management Software User’s Guide
Mapping CoS Priorities to Egress Queues
This procedure explains how to change the default mappings of CoS priorities to egress priority queues, shown in Table 2 on page 97. This is set at the switch level and applies to all ports. This procedure also enables and disables QoS.
To change the mappings, perform the following procedure:
1.From the Main Menu, type A to select Advanced Switch Configuration.
The Advanced Switch Configuration Menu is shown in Figure 14 on page 59.
2.From the Advanced Switch Configuration Menu, type S to select Quality of Service Configuration.
The Quality of Service Configuration Menu is shown in Figure 23.
Advanced Switch Configuration
[T]raffic Class Configuration [P]ort Priority Configuration [Q]uit to previous menu
Command>
Figure 23. Quality of Service Configuration Menu
3.From the Quality of Service Configuration Menu, type T to select Traffic Class Configuration.
Section I: Using the Menus Interface | 99 |
