7

A

SYNC indicator is not lit. L’indicateur SYNC n’est pas allumé. El indicador SYNC no está encendido.

56

RECORDING (1) – AUTOMATIC DIGITAL-SOURCE SYNCHRO RECORDING (1-TRACK RECORDING)

6 If the track changes (when the input source is CD or MD), or if the next start ID is detected (when the input source is DAT or DCC), 1-track recording will be canceled and the unit will enter the record-pause mode.

ÖIf the recording of another track is required, repeat steps 3 to 5.

7 After recording is complete press the 7 button to end the recording.

ÖThe display will show “PMA REC” while recording the track data and then the unit stops recording.

ÖA if the “SYNC” indicator is not lit after 1-track synchro recording, the next track to be recorded can be confirmed on the source device. (Automatic recording cannot begin unless the “SYNC” indicator is lit.)

Cautions when making digital recordings from

DAT

Be sure to enter the start IDs on DAT tapes in positions before the beginning of the audio portion. DAT tapes that are originally recorded using the DAT auto ID function records the start ID slightly after the beginning of the actual recording. This recorder uses the start ID to indicate the transition between tracks in a digital recording from DAT tape.

The following problems could occur when automatic updating of track numbers is used during automatic digital-source synchro recording or manual digital recording.

The beginning of a track is not recorded.

A new track number is created slightly after the beginning of a new track.

The beginning of the next track is recorded at the end

of a recording.

Manual recording of the DAT tape start ID is therefore recommended to avoid these problems.For information on DAT operations, refer to the operating instructions provided with the DAT recorder.

<PRE1282> En

Page 56
Image 56
Americana Appliances CDR-850 manual Dat