2.2Programming with the Programming Key
The CC891 Programming Key allows you to store or copy programming information from your control panel. After storing information in the programming key, you can easily program other
If you connect the programming key to the control panel when it is disarmed, the key automatically initiates a data transfer to the control panel’s memory.
If you have a new programming key, enter Installer’s Programming Mode, program the system as required, and connect the programming key to the control panel.
To connect the programming key, locate the socket labelled PROGRAMMING KEY at the top of the printed circuit board (PCB) next to the Auxiliary Module socket. Observe the triangular markings on the PCB and align them with the markings on the programming key.
To copy data from the control panel data to the programming key:
1.Enter the Installer Code (the default is 1234) and press [#] to enter Installer’s Programming Mode.
2.Enter [9 6 2 #].
Refer to Section 2.4.5 Command 962 – Copy the Control Panel Memory to the Programming Key on page 12 for more information.
3.Enter [9 6 0 #] to exit from the Installer’s Programming Mode.
Two beeps sound and the system returns to the disarmed state. Before removing the programming key, wait 2 sec for the activity LED to return to its normal state. The programming key becomes your standard data pattern for future control panel programming.
If you enter Installer’s Programming Mode, insert a programming key, and change the data in any location. The data for both the programming key and the control panel is changed at the same time.
If you do not enter Installer’s Programming Mode first, connecting the CC891 Programming Key to the control panel when the programming key memory is blank corrupts the control panel’s memory. If this occurs, you must return the control panel to Bosch Security Systems, Inc. to unlock the control panel’s memory. A service fee is charged.
2.3Programming Option Bits
When programming some locations, there are up to four options per location. You can select one, two, three, or all four options for each location, but you can program only one value for the location. Calculate this value by adding the option bit numbers together.
Example
To select Options 1 and 4 for Location 177, add the numbers together and program the sum. In this example, program a 5 in the location (1 + 4 = 5).
Table 4: Programming Option Bits Example
Option Description
1Allow dialer reporting functions
2Enable remote arming by telephone
4Enable answering machine bypass only when armed
8Enabled = Use Bell 103 for FSK format Disabled = CCITT V21 format
2.4Installer’s Programming Commands
There are ten commands you can use in Installer’s Programming Mode. To issue the command, enter the command number and press [#].
Table 5: Installer’s Programming Mode Commands
Command Function
959Test the programming key
Refer to Section 2.4.2 on page 11.
960Exit from Installer’s Programming Mode Refer to Section 2.4.3 on page 12.
961Reset the control panel to factory defaults Refer to Section 2.4.4 on page 12.
962Copy the control panel memory to the programming key
Refer to Section 2.4.5 page 12.
963Copy the programming key data to the control panel memory
Refer to Section 2.4.6 on page 12.
964Erase the programming key
Refer to Section 2.4.7 on page 13.
965Set up domestic dialing format Refer to Section 2.4.8 on page 13.
966Enable or disable Auto Step Mode Refer to Section 2.4.9 on page 13.
999Display the software version number or control panel type
Refer to Section 2.4.10 on page 14.
10 | Bosch Security Systems, Inc. 12/08 |
