2.4.7Command 964 – Erase the Programming Key
This command erases all data from the programming key. You can only use the CC891 Programming Key with the
To erase the programming key:
1.Enter the Installer Code (the default is 1234) and press [#] to enter Installer’s Programming Mode. Two beeps sound and the STAY and AWAY indicators flash on the remote codepad to indicate you entered Installer’s Programming Mode. The remote codepad shows the data stored in Location 000.
2.Connect the programming key to the PROGRAMMING KEY pins (next to the Auxiliary Module socket) at the top of the control panel’s printed circuit board.
3.Enter [9 6 4 #].
Two beeps sound after the data is deleted.
4.Enter [9 6 0 #] to exit from the Installer’s Programming Mode.
The STAY and AWAY indicators turn off on the remote codepad to indicate that the system is disarmed.
5.Remove the programming key from the control panel.
Failing to exit from the Installer’s Programming Mode before removing the programming key can corrupt the programming key.
2.4.8Command 965 – Set Up Domestic Dialing Format
Command 965 simplifies the setup of the domestic dialing format to a
9.0Domestic Dialing on page 40 for more information.
To set up domestic dialing format:
1.Enter the Installer Code (the default is 1234) and press [#] to enter Installer’s Programming Mode. Two beeps sound and the STAY and AWAY indicators flash on the remote codepad to indicate you entered Installer’s Programming Mode. The remote codepad shows the data stored in Location 000.
2.Enter [9 6 1 #].
The command automatically sets Receiver 1 to domestic reporting and sets the locations shown in bold in Table 6 on page 14 for Receiver 2 only. No other locations are changed when you issue Command 965.
All domestic telephone numbers are stored in Locations 466 to 513. For more information, refer to Section 9.2 Setting Up and Programming Domestic Reporting on page 41.
As shown in Table 6 on page 14, the transmission format is automatically set for domestic dialing and the Subscriber ID Number set for one identification beep. All reports, except Zone Status reporting and System Status reporting, are allocated to Receiver 1 for domestic dialing.
Zone Status Reports, including Zone Bypass, Zone Trouble, Sensor Watch, and Alarm Restore codes, and System Status Reports, including AUX Power Supply Fail, AC Fail, Low Battery, and Access Denied Reports, are allocated to Receiver 2 and do not report unless Receiver 2 is also set up to report.
2.4.9Command 966 – Enable or Disable Auto Step Mode
This command allows you to enable or disable Auto Step Mode when programming in Installer’s Programming Mode. When programming with the remote codepad, there is no visual indication that Auto Step Mode is enabled.
If the Auto Step Mode is enabled, pressing [*] automatically moves you to the next programming location.
If Auto Step Mode is disabled, you must move to the next location by pressing [#]. The example below shows that Auto Step Mode is very useful when programming successive locations.
To enable Auto Step Mode:
1.Enter the Installer Code (default = 1234) and press [#] to enter Installer’s Programming Mode. Two beeps sound and the STAY and AWAY indicators flash on the remote codepad to show you entered Installer’s Programming Mode. The remote codepad displays the data stored in Location 000.
2.Enter [9 6 6 #].
Two beeps sound.
To disable Auto Step Mode:
Enter [9 6 6 #].
Two beeps sound.
Bosch Security Systems, Inc. 12/08 | 13 |
