Bosch Appliances ICP-CC404 Dialer Reporting Formats, Transmission Formats, Contact ID Format

ICP-CC404 Installation Guide 10.0 Dialer Reporting Formats

10.0Dialer Reporting Formats

10.1Transmission Formats

The ICP-CC404 Control Panel provides a number of transmission formats for its dialing and communication features. Program the transmission format for Receiver 1 in Location 033 and the transmission format for Receiver 2 in Location 073 (refer to Section 11.4 Transmission Format for Receiver 1 and Receiver 2 on page 47). The control panel is set at the factory to report in the Contact ID Format.

10.1.1 Contact ID Format

Contact ID Format can identify hundreds of protection zones by their unique codes. This format provides a single-digit Event Qualifier and a three- digit Event Code that quickly identifies the reported condition.

In general, Contact ID Format is very simple because most of the Event Codes and Point ID Codes are predefined. The base station software usually can identify an alarmed zone by its Point ID Code and usually pays little attention to the Event Code.

Refer to Table 33 on page 43 for more information about the ICP-CC404 Point ID Codes.

Table 32: Contact ID Format Breakdown

Subscriber ID
Number	Qualifier		Event Code	Group Number	Point ID Number
SSSS	Q		XYZ	GG	CCC
Four-digit	Event Qualifier, which provides		Event Code	Group Number	Point ID Number
Subscriber ID	specific event information:		(comprised of three	(comprised of two	(comprised of three
Number	1	– New event or opening	hex digits)	hex digits)	hex digits)
	3	– New restore or closing

42 Bosch Security Systems, Inc. 12/08 F01U089401-02