ICP-CC404 Installation Guide 21.0 Specifications
21.0 Specifications
Table 66: Specifications
|
|
Temperature Range | 0oC to +45 oC |
| (+32 oF to +113 oF) |
Humidity | 10% to 95% |
Power Source | TF008 Plug Pack – |
| 240 VAC/18 VAC @ 1.3 A |
Standby Current | 65 mA |
Current Draw In Alarm | 115 mA |
|
|
Current Draw In Alarm | 105 mA |
with Codepad |
|
Backup Battery | 6 Ah/12 VDC Rechargeable |
| sealed lead acid battery |
Dimensions (case, | 30.6 cm x 26.2 cm x 8.4 cm |
packed in carton) | (12.1 in. x 10.3 in. x 3.3 in.) |
Weight | 2.5 kg (5.5 lb) |
Supplier Code | N771 |
New Zealand Telepermit | PTC 211/98/085 |
The Austel permit issued for this product is subject to the following conditions: The
21.1Warranty Statement
Bosch Security Systems, Inc. warrants this product to be free from defects in material and workmanship for a period of three years from the date of manufacture as indicated by the date stamp or the serial number on the product.
Defective units returned by the purchaser at their own expense during this period will be repaired or replaced at the option of the manufacturer. The repair or replacement is free of charge provided that the defects were not incurred during shipping or handling, or the damage was not due to causes beyond the control of Bosch Security Systems, Inc., such as lightning, excessive voltage, mechanical shock, or damage arising out of abuse, alteration, or improper application of the equipment.
21.2Advice to Users
The Austel permit issued for this product is subject to this condition:
The
21.3New Zealand Telepermit Notes
•The grant of a telepermit for a device does not indicate telecom acceptance of responsibility for the correct operation of the device under all operating conditions.
•This equipment shall not be used in any manner that could constitute a nuisance to other telecom customers.
•Disconnect this equipment immediately if it becomes physically damaged and arrange for its disposal or repair.
•The transmit level from this device is set at a fixed level, so there might be circumstances where the performance is less than optimal.
Before reporting such occurrences as faults, please check the line with a standard telepermitted telephone and do not report a fault if the telephone performance is satisfactory.
•This device is equipped with pulse dialing while the telecom standard is DTMF tone dialing. There is no guarantee that telecom lines will always continue to support pulse dialing.
Use of dialing, when this equipment is connected to the same line as other equipment, can give rise to bell tinkle or noise and can also cause a false answer condition. If problems such as this occur, the user should not contact the Telecom Faults Service.
•This equipment is set up to carry out test calls at
The timing set for test calls from this equipment may be subject to drift. If this proves to be inconvenient and your calls are interrupted, discuss the problem of timing with the equipment installer. Do not report the matter as a fault to Telecom Faults Service.
•This equipment shall not be set up to make automatic calls to the Telecom 111 Emergency Service.
This equipment should not be used under any circumstances that may constitute a nuisance to other Telecom customers.
•In the event of any problem with this device, disconnect the system battery, AC mains supply, and the telephone line. The user must arrange with the supplier of the device for the necessary repairs.
If the matter is reported to telecom as a wiring fault and the fault is proven to be due to this product, a
84 | Bosch Security Systems, Inc. 12/08 |
