Canon C3200 manual Orientation, Platen Glass, Vertical Placement Horizontal Placement Feeder

1

Introduction to Sending Functions

Orientation

You can place an original either vertically or horizontally. Always align the top edge of your original with the back edge of the platen glass (by the arrow in the top left corner), or the back edge of the feeder.

Platen Glass

Place the original	Place the original
face down.	face down.

Vertical Placement Horizontal Placement

Feeder

Place the original	Place the original
face up.	face up.

Vertical Placement Horizontal Placement

NOTE

•If the top edge of the original is not aligned with the back edge of the platen glass (by the arrow in the top left corner), your original may not be scanned correctly, depending on the scan and send modes that you have set.

•Originals of the following sizes can be placed either vertically or horizontally. However, the scanning speed for horizontally placed originals is somewhat slower than for vertically placed originals. Place originals horizontally when scanning with a Preset Zoom, such as when enlarging an LTR original onto 11" x 17" paper.

-Platen glass: LTR, STMT

-Feeder: LTR

•Horizontally placed LTR and STMT originals are referred to as LTRR and STMTR.

•11" x 17" and LGL originals must be placed horizontally.

1-36Placing Originals