Dell R510 owner manual Installing a Redundant Power Supply, 111, Velcro strap Release latch

Figure 3-17. Removing and Installing a Redundant Power Supply

1

2

			4	3
1	power supply	2	power supply handle
3	velcro strap	4	release latch

Installing a Redundant Power Supply

1Verify that both power supplies are of the same type and have the same maximum output power.

NOTE: The maximum output power (shown in watts) is listed on the power supply label.

2Slide the new power supply into the chassis until the power supply is fully seated and the release latch snaps into place. See Figure 3-17.

NOTE: If you unlatched the cable management arm in step 2 of the previous procedure, relatch it. For information about the cable management arm, see the system’s rack documentation.

3Connect the power cable to the power supply and plug the cable into a power outlet.

CAUTION: When connecting the power cable, secure the cable with the Velcro strap.

Installing System Components

111