Message | Causes | Corrective Actions |
|
|
|
Unused memory | The memory configuration is | Reconfigure the memory for |
detected. DIMM’s | not optimal for Advanced | Advanced ECC Memory |
installed in the | ECC Memory Mode. | Mode, or change the |
following slot | Modules in the specified | memory mode to Optimized |
are not available | slots are unused. | or Sparing in the BIOS setup |
when in |
| screen. See "System |
advanced ECC |
| Memory" on page 114. |
mode: x,x,x |
|
|
|
|
|
Warning: A fatal | A fatal system error | Check the SEL for |
error has caused | occurred and caused the | information that was logged |
system reset! | system to reboot. | during the error. See the |
Please check the |
| applicable troubleshooting |
system event log! |
| section in "Troubleshooting |
|
| Your System" on page 169 for |
|
| any faulty components |
|
| specified in the SEL. |
|
|
|
Warning: Control | The control panel is not | Install the control panel, or |
Panel is not | installed or has a faulty cable | check the cable connections |
installed. | connection. | between the display module, |
|
| the control panel board, |
|
| and the system board. |
|
| See "Integrated Storage |
|
| Controller Card" on |
|
| page 129. |
|
|
|
Warning! No micro | Micro code update failed. | Update the BIOS firmware. |
code update |
| See "Getting Help" on |
loaded for |
| page 199. |
processor n |
|
|
56
About Your System
