Dell R510 Sector not found, Seek error, Seek operation, Shutdown failure, Amount, Changed

Message	Causes	Corrective Actions
Sector not found	Faulty hard drive, USB	Replace the USB medium or
Seek error	device, or USB medium.	device. Ensure that the USB
		or SAS backplane cables are
Seek operation
		properly connected. See
failed
		"Troubleshooting a USB
		Device" on page 170 or
		"Troubleshooting a Hard
		Drive" on page 181 for the
		appropriate drive(s) installed
		in your system.
Shutdown failure	General system error.	See "Getting Help" on
		page 199.

Sparing mode The memory configuration

disabled. For does not match the setting

sparing mode, in BIOS. The BIOS setting

matched sets has been disabled. of three must

be populated across slots.

Reconfigure the memory modules for Memory Sparing mode. See "System Memory" on page 114.

The amount of	Memory has been added or	If memory has been added or
system memory has	removed or a memory	removed, this message is
changed	module may be faulty.	informative and can be
		ignored. If memory has not
		been added or removed,
		check the SEL to determine
		if single-bit or multi-bit
		errors were detected and
		replace the faulty memory
		module.
		See "Troubleshooting
		System Memory" on
		page 177.

52

About Your System