Figure 3-26. Installing and Removing the Heat Sink

1

2

1 heat sink heat-sink

2

retention screws (4)

10Rotate the processor shield upward and out of the way. See Figure 3-27.

11Lift the processor out of the socket and leave the release lever up so that the socket is ready for the new processor.

CAUTION: Be careful not to bend any of the pins on the ZIF socket when removing the processor. Bending the pins can permanently damage the system board.

NOTE: In single-processor configurations, a processor must be installed in socket CPU1. Install the blank in socket CPU2 only.

140

Installing System Components

Page 140
Image 140
Dell R510 owner manual Retention screws