Dell R510 owner manual Embedded Server Management Screen

Option	Description
Serial Port Address	Sets the serial port addresses for the two serial devices.
(Serial Device 1=COM1,	NOTE: Only Serial Device 2 can be used for Serial Over
Serial Device 2=COM2	LAN (SOL). To use console redirection by SOL, configure
default)
	the same port address for console redirection and the
	serial device.
External Serial Connector	Specifies whether Serial Device 1, Serial Device 2,
(Serial Device1 default)	or Remote Access Device has access to the
	external serial connector.
	NOTE: Only Serial Device 2 can be used for Serial Over
	LAN (SOL). To use console redirection by SOL,
	configure the same port address for console redirection
	and the serial device.
Failsafe Baud Rate	Displays the failsafe baud rate used for console
(115200 default)	redirection. BIOS attempts to determine the baud rate
	automatically. This failsafe baud rate is used only if the
	attempt fails. This rate should not be adjusted.
Remote Terminal Type	Sets the remote console terminal type, either
(VT100/VT220 default)	VT100/VT220 or ANSI.
Redirection After Boot	Enables or disables BIOS console redirection when the
(Enabled default)	operating system is loaded.

Embedded Server Management Screen

NOTE: This section is applicable to systems with hot-swappable hard drives only.

Option	Description
Front Panel LCD	Options are User Defined String, Model Number, or None.
Options	If the LCD Home display is set to anything other than User
	Defined String, Model Number, or None, this option in BIOS
	will display Advanced. You will not be able to edit this setting in
	BIOS until it is set back to User Defined String, Model Number,
	or None through another LCD configuration utility (such as the
	optional BMC or iDRAC6 Configuration Utility or LCD panel
	menu).
User-Defined	You can enter a name or other identifier for the system, to be
LCD String	displayed on the LCD module screen.

70

Using the System Setup Program and UEFI Boot Manager