Message | Causes | Corrective Actions |
|
|
|
Plug & Play | Error encountered in | Install the NVRAM_CLR |
Configuration | initializing PCIe device; | jumper in the clear position |
Error | faulty system board. | (pins 1 and 3) and reboot the |
|
| system. See Figure |
|
| jumper location. If the |
|
| problem persists, |
|
| see "Troubleshooting |
|
| Expansion Cards" on |
|
| page 184. |
|
|
|
Quad rank DIMM | Invalid memory | Ensure that the memory |
detected after | configuration. | modules are installed in a |
single rank or |
| valid configuration. |
dual rank DIMM in |
| See "General Memory |
socket. |
| Module |
|
| Installation Guidelines" on |
|
| page 115. |
Read fault
Requested sector not found
The operating system cannot read from the hard drive, optical drive, or USB device, the system could not find a particular sector on the disk, or the requested sector is defective.
Replace the optical medium, USB medium, or USB device. Ensure that the USB cables, SAS/SATA backplane cables, or optical drive cables are properly connected.
See "Troubleshooting a USB Device" on page 170, "Troubleshooting an Optical Drive" on page 180, or "Troubleshooting a Hard Drive" on page 181 for the appropriate drive(s) installed in your system.
SATA Port x | There is no device connected Information only. |
device not | to the specified SATA port. |
found |
|
About Your System
51
