Dell R510 owner manual Front-Panel IO Module Optional, Installing the Control Panel Assembly

Installing the Control Panel Assembly

1Install the control panel board in the system chassis and secure with the two Phillips screws. See Figure 3-32.

2Connect the display module cable to the control panel board. See Figure 3-32.

3Connect the control panel cable to the control panel board. See Figure 3-32.

4Connect the USB cable to the control panel board. See Figure 3-32.

5Close the system. See "Closing the System" on page 89.

6Reconnect the system to the power source and turn on the system and attached peripherals.

7If applicable, replace the front bezel. See "Installing the Front Bezel" on page 87.

Front-Panel IO Module (Optional)

Removing the Front-Panel IO Module (Twelve–Hard-Drive System)

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1If installed, remove the front bezel. See "Removing the Front Bezel" on page 86.

2Turn off the system and attached peripherals, and disconnect the system from the electrical outlet and peripherals.

3Using a Torx screwdriver, remove the three screws that secure the front panel IO module to the system chassis and remove the module.

4Remove the single screw securing the bracket to the module and remove the bracket.

5Unlatch and disconnect the front-panel IO cable at back of the module. See Figure 3-33.

154

Installing System Components