Fujitsu SRS-2100 manual Using X.28 Commands, Data Users Guide

SRS -2100 Data Operation (	Chapter 4
Using X.28 Commands	2. To disconnect, hold down CTRL
	as you press P. Wait for the *
The procedure for making the	prompt to appear, and then
connection with X.28 is similar to	enter the command CLR and
the above but requires no explicit	press <CR>. The call
command:	disconnects, the words CLR
	CONF appear on your screen,
1. Enter the number to be dialed,	and the steady terminal symbol
and then press <CR>. A	disappears.
blinking terminal symbol
appears on the phone's display	For instructions on viewing
next to the word DATA. When	parameters or using off-line
the connection is made, the	commands, or for additional
display returns to normal, except	information on other
that a steady terminal symbol	communication parameters and
continues to be shown to the	considerations, please refer to the
left of DATA.	Data User's Guide.
	Note: The AT and X.28 escape
	sequences shown above (+++
	and CTRL-P) are the default
	values. If these have been
	changed on your terminal, refer
	to the Data User's Guide.

Notes

Page 4-4