Fujitsu SRS-2100 manual Connecting to, Network, Entering Spids and a D Channel TEI

SRS -2100 Installation (	Appendix B
CONNECTING TO THE	If you have only one SPID for
NETWORK	both voice and data, enter the
	SPID as a voice SPID only. Do
When you receive your SRS-2100,	not enter the same SPID twice (for
plug the telephone line from the	voice and data).
wall into the LINE socket on the
back of the set. If the display	Do not change your SPID unless
shows a date and time, you have	told to do so by your service
power. If the display does not	provider. In most cases, digital
light up, you may need a power	sets will not work without the
supply to connect to the wall	correct SPID number. If the SPID
socket and to the 40 V DC power	number is wrong, the set displays
socket on the back of the set.	the message SPID NG. Enter the
	correct SPID number, and then
If you are connecting power for	disconnect and reconnect power
the first time, you should see the	to make the set function normally.
message SPID NG. See the next
section to enter a Service Profile	To enter the service profile
Identifier (SPID).	identifiers and the terminal
	endpoint identifier, follow these
	steps:
ENTERING SPIDS AND A D-
CHANNEL TEI	1. Press REGISTER (softkey 4) 8,
	ENTER (softkey 1).
The Service Profile Identifier
identifies your set to the network.	The message ENTER VOICE SPID
If you have a voice/data terminal,	appears, with the current SPID
you may need two SPIDs, one for	number (if any) shown below it.
voice and one for B-channel
circuit-switched data. You may	ENTER VOICE SPID
also need to enter a D-channel	ID=000000000000
Terminal Endpoint Identifier (TEI)	. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
for packet-switched data calls.	. . . .
You can enter the data SPID and	ENTER NEXT CLEAR
TEI either through this procedure	REGISTER
or through procedures in the
Data User's Guide.	2. Dial your voice SPID number
	and press ENTER.
	The display prompts for the data
	SPID.

Page B-4