Fujitsu SRS-2100 manual If you are already using Headset and talking on, Receiving Headset Calls

Chapter 2	( SRS -2100 Voice Features
If you are already using the		Note: Onhook dialing. In place
headset and talking on		of steps 1 and 2, you can dial
another call		the number first and then press
		SPEAKER. The phone
1. Handle the existing call in one of		automatically dials the number.
the following ways:		The number you enter remains
		available for dialing for about
a. End the call by pressing		three minutes.
SPEAKER. Then press
SPEAKER again to get a dial		You can also use a one-touch
tone.		button after handling the
or		existing call. This automatically
		selects an idle CA and dials the
b. Retain the call by pressing an		number. Skip step 2.
idle Call Appearance button,
which gives you a dial tone.		(See also "Handsfree, Handset,
(The call is automatically put		and Headset Modes", in Chapter
on hold.)		3, "Local Features".)
2. Dial the desired number by
pressing the keys on the		Receiving Headset Calls
numeric keypad.
		An incoming call makes the Call
3. If your call is not answered,		Appearance's LED flash green.
hang up by p ressing SPEAKER.
		If you are not talking on
4. If your call is answered,		another call
converse with the called party.
		Place the headset on your head in
5. When the conversation is over,		a position comfortable for hearing
hang up by pressing SPEAKER.		and talking. If necessary, unplug
Note the displayed call		the handset from the jack on the
duration; it vanishes after about		phone's left side. Plug the
three seconds.		headset into the same jack. Also
		check that headset mode is
You may then pick up your		activated. (See Chapter 3 for
original call, if it was held, by		details.)
pressing SPEAKER and, if
necessary, the call's CA button.

Page 2-9