Fujitsu SRS-2100 manual If you are already talking on another call

Chapter 2 ( SRS -2100 Voice Features

5.When your conversation ends, hang up by replacing the handset in its cradle. Note the displayed call duration vanishes after about three seconds.

Note: Onhook dialing. In place

of steps 1 and 2, you can dial the number first and then pick up the handset. The phone automatically dials the number. The number you enter remains available for dialing for about three minutes.

You can also use a one-touch button, which automatically selects an idle CA and dials the number. Steps 1 and 2 are therefore unnecessary when you use a one-touch button. Once the call is dialed, you can pick up the handset.

If you are already talking on another call

1.Handle the active call in one of the following ways:

a.End the call by pressing the button in the handset cradle to get a dial tone. (You can also hang up the handset and pick it up again.)

or

b. Retain the call by pressing an idle Call Appearance button to get a dial tone. (The call is automatically put on hold.)

or

c.Press DROP. ⎪(5ESS⎪

2.To make your call, dial the desired number by pressing the keys on the numeric keypad.

3.If your call is not answered, you can hang up as follows:

a.Replace the handset in its cradle.

or

b. Press the button in the handset cradle to get a dial tone.

4.If your call is answered, converse with the called party.

5.When your conversation ends, you have these choices:

∙Hang up by replacing the handset in its cradle. Note the displayed call duration; it vanishes after about three seconds.

or

∙If you put your original call on hold, pick up the call by pressing its red-flashing Call Appearance button.

Note: You can also use a one- touch button after handling the active call. This automatically dials the number. Skip step 2.

Page 2-3