Fujitsu SRS-2100 manual NT1 Settings, Fujitsu Terminal Equipment, Termination Resistors TR

SRS -2100 Installation (	Appendix B
For use with the printing	NT1 Settings
application, Fujitsu has included	Termination
two laser printer compatible paper
template with the SRS-2100 User’s	Many NT1's have settings
Guide. As an alternative, you
	available to turn Termination ON
may print, type, or write in the
	or OFF. If the setting is ON they
needed designation on the
	may also have settings to select
template. Additional templates
	either 50 or 100 Ohms.
may be purchased from your
distributor or from Fujitsu.	Sometimes these settings are
Do not separate the two 2100	accomplished via switches, other
	times they are done with jumpers.
templates or remove the margin	Follow the NT1 manufacturer
material before printing.
All other loose materials must be	instructions to set the
	Termination to ON or OFF as
removed before placing the
	needed.
template in the laser printer.
Failure to remove loose materials
may result in a paper jam in the	Timing
printer. Templates are fed via the	NT1's also have a timing setting
manual feed tray.
	with the options FIXED or
Please address questions about	ADAPTIVE. On some NT1's the
	options may be labeled PB or
the program to FNC TAC, at 1-
	PTP. PB is equivalent to FIXED
800-228-ISDN.
	and PTP is equivalent to
	ADAPTIVE. Timing settings in
Fujitsu Terminal Equipment	the following discussions are
	based on NT1 manufacturer
Termination Resistors (TR)
	recommendations.
Fujitsu ISDN phones have a
Terminating Resistor (TR) switch
on the back of the set. The
options are ON and OFF.
Fujitsu TR's are equivalent to 100
Ohms in the ON position. Refer
to the following discussions for
TR setting recommendations.
	Single Unit Installations

Page B-24