Fujitsu SRS-2100 Data Operation, Using the Terminal Adapter, Making and Terminating a Data Call

Chapter 4 ( SRS -2100 Data Operation

CHAPTER 4

DATA OPERATION

The SRS-2100 Digital Set with a Terminal Adapter allows you to use the set for data applications. Please refer to the Fujitsu Data User's Guide for information on how to set up and configure the Terminal Adapter for proper operation.

5:20 PM Tuesday January 4

UNA-LIST DATA CLEAR DIR-LIST

Service

1 2 3 4

Standard Softkey Layout

(The DATA softkey label appears only if you have a voice/data terminal.)

Note: Softkey 1 also serves as the ENTER key (for entering information as indicated in this User's Guide).

USING THE TERMINAL

ADAPTER

This chapter describes three ways to make a data call using the integrated Terminal Adapter (TA) in your Digital Set.

∙Using the DATA softkey (second button from the left under the display)

∙Using AT commands at your terminal

∙Using the X.28 commands at your terminal

There are three LEDs below the multifunction buttons of the SRS- 2100. DTR (Data Terminal Ready) must be steady green to establish a connection.

Transmitting data from your terminal causes the TXD (Transmit Data) LED to flash, and receiving data causes the RXD (Receive Data) LED to flash.

MAKING AND TERMINATING A DATA CALL

You can start or end a data call either manually or by using commands at your terminal, as described in the following sections.

Using the DATA Key

To make a data call using the digital set DATA key, use the following steps:

Page 4-1