Chapter 4 | ( SRS |
Once the call connects, the terminal symbol stops blinking.
3.To disconnect a data call manually, press DATA (softkey 2). The terminal symbol on the display disappears.
Using AT Commands
To make a data call using AT commands from an asynchronous terminal, follow these steps:
1.From your terminal, enter the AT dial command (ATD) and the number you wish to dial (2345678) for example), ending with a carriage return (shown here as <CR>):
ATD2345678 <CR>
The letters AT stand for Attention, D for Dial. (Either ATD or atd will work.) A blinking terminal symbol appears on the phone's display next to the word DATA.
When the call connects, the word CONNECT or COM appears on the terminal screen. The phone's display returns to normal, except that a steady terminal symbol continues to be shown to the left of DATA.
If the call cannot be completed (the called terminal was busy or did not answer) an error message appears on your terminal screen.
2.To disconnect the call, use the following procedure:
∙Enter +++ from your terminal OK appears on the terminal screen.
∙Enter ATH <CR> from the terminal.
The call disconnects, and the terminal symbol on the phone's display disappears.
Note: When you use the AT commands, the message ERROR will appear on the terminal screen if the command is entered incorrectly. Please refer to the Data User's Guide for more information on using the AT commands.
Page
