Chapter 3 | ( SRS |
2.To select the option you want, press the appropriate key(s) on the numeric keypad to dial 1 to 13 (do not press one of the four buttons under the screen) and then press ENTER (softkey 1). If you notice a mistake after pressing ENTER and want to cancel the keypad entry, press asterisk (*). To clear an entry before pressing ENTER, press CLEAR (softkey 3).
3.To exit Service Mode, press REGISTER (softkey 4). If you forget to exit, Service Mode is automatically canceled after four minutes, or whenever you pick up the handset or press
SPEAKER.
Whenever REGISTER is pressed, it either enters or exits Service Mode, no matter what else may be in progress.
Note: If you enter Service Mode during a call, special features such as Call Pickup and Call Forwarding are temporarily disabled. However, regular calling controls such as HOLD, SPEAKER,
Once you are familiar with the menu choice numbers, you can go directly to the one you want after pressing REGISTER. For example, you can abbreviate the key sequence REGISTER NEXT 7 ENTER to REGISTER 7 ENTER, getting to the RINGER screen without displaying the other menus shown in this section.
Notes on Entering
Information
When the displayed entry is acceptable, press ENTER to retain it and display the next parameter screen.
To change a numerical entry before you press ENTER, press CLEAR (softkey 3) and enter the desired value.
To change a menu selection or a numerical entry after you press ENTER, press asterisk (*). In some cases, this returns you to the preceding data entry screen, where you can enter the correct information. In other cases, you return to the Service Mode main menu and must redo the procedure from there.
PROGRAMMING A BUTTON FOR ONE-TOUCH DIALING
Page
