Fujitsu SRS-2100 manual Press Drop

Chapter 2	( SRS -2100 Voice Features
If you are not talking on			or
another call		Press DROP.	⎪(5ESS⎪
1. Press the SPEAKER button. Its		Note: Onhook dialing. In place
LED will light red and you will
		of steps 1 and 2, you can dial
hear a dial tone (if not, press an
		the number first and then press
idle Call Appearance). If this
		SPEAKER. The phone
connects you with a ringing call,
		automatically dials the number.
follow the procedure "If you are
		The number you enter remains
already talking on another call".
		available for dialing for about
2. Dial the desired number by		three minutes.
pressing the keys on the		You can also use a one-touch
numeric keypad.
		button, which automatically
3. If your call is not answered,		selects handsfree operation on
		an idle CA and dials the number.
press SPEAKER to hang up.
		Steps 1 and 2 are therefore
4. If your call is answered,		unnecessary when you use a
		one-touch button.
converse with the called party.
(If the MIC-OFF LED is red, the		(See also "Handsfree, Handset,
microphone has been turned off.
		and Headset Modes", in Chapter
Press MIC-OFF to turn it back
		3, "Local Features".)
on.)
You can turn off the microphone		If you are already talking on
by pressing the MIC-OFF button;
		another call
its LED will turn red. No sound
will then be transmitted to the		1. Handle the active call in one of
called party, allowing you to hold
		the following ways:
a private conversation with others
in the room. To turn the		a. End the call by pressing
microphone back on, press MIC-
		SPEAKER. Press SPEAKER
OFF again; its red LED will go
		again to get a dial tone.
dark.
			or
5. When the conversation is over,		b. Retain the call by pressing an
hang up by pressing the
		idle Call Appearance button,
SPEAKER key. Note the call
		which gives you a dial tone.
duration vanishes after about
		(The call is automatically put
three seconds.
		on hold.)	" Continued"

Page 2-5