Chapter 3 | ( SRS |
Message logging works in two modes:
∙The Logging mode, which stores messages in a history file without displaying them
∙The History mode, which displays messages stored in the history file. The history file can hold up to 24 messages at a time.
This section covers the procedures to:
∙Start and stop message logging
∙Review logged messages
Note: When you stop message logging, all messages stored in the history file are saved and can be reviewed at a later time.
Appendix F provides the System Administrator or service technician with information useful in decoding messages. (Because of the limited space on your display, messages appear as a set of codes and abbreviations.)
Starting or Stopping Message Logging
You go through the same sequence of menus to start or stop message logging.
1.Press REGISTER (softkey 4), 9, ENTER (softkey 1).
The following screen appears:
MESSAGE LOGGING - SELECT ITEM (1- 3)
1:
3:HISTORY MODE
ENTER NEXT CLEAR REGISTER
2.Make your selection.
To start message logging, press 1, then press ENTER.
The message MESSAGE LOGGING START SELECTED appears.
To stop message logging, press 2, then press ENTER.
The message MESSAGE LOGGING STOP SELECTED appears.
3.To return to normal operations, press REGISTER.
The standard display screen reappears.
Reviewing Logged Messages
To review messages in History mode, complete the following steps:
1.Press REGISTER (softkey 4), 9, ENTER (softkey 1). This screen appears:
Page
