Fujitsu SRS-2100 manual B-12

SRS -2100 Installation ( Appendix B

1.Press 1 and ENTER (softkey 1). This screen appears:

CALL APPEARANCE REGISTRATION SELECT ASSIGN KEY

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

. . . .

ENTER NEXT CLEAR REGISTER

The set's indicators show button status as follows:

∙Green indicates a button already assigned to a Call Appearance.

∙Red indicates a button already assigned to a DN, to a network feature, or to a local feature such as one-touch.

∙Unlit indicates an unassigned button.

2.Press the button to which you want to assign a Call Appearance.

You can press any unlit or green multifunction button. If you press a red button, the display shows the message INVALID SELECTION, and the set waits for you to press a valid button.

∙If you press a green button, the display shows the current number assigned to that multifunction button. You can either enter a new number to replace the current number or cancel the current number.

∙If you press an unlit button, the screen looks like this:

CALL APPEARANCE MODE

CA=(XX)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

. . . .

ENTER NEXT CLEAR REGISTER

XXis the number of the multifunction button you pressed. If you pressed a green-lit button, the current feature number appears after CA=. The new number you enter replaces this number.

3.You now have two choices:

∙ To add or change the CA number, enter the new number and press ENTER.

or

∙To cancel the CA number, press CLEAR (softkey 3) and then ENTER.

The final screen looks like this:

CA=XX(XX)

COMPLETED

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

. . . .

ENTER NEXT CLEAR REGISTER

Page B-12