
| Configuration Commands |
Table 78 SSHD Configuration commands | |
|
|
Command | Description |
|
|
no ssh enable | Disables the SSH server. This is the default for the SSH server. |
| Command mode: Global configuration |
|
|
show ssh | Displays the current SSH server configuration. |
| Command mode: All |
|
|
RADIUS server configuration
NOTE: See the HP 10Gb Ethernet
The following table describes the RADIUS Server Configuration commands.
Table 79 RADIUS Server Configuration commands
Command | Description |
|
|
[no] | Sets the primary RADIUS server address and shared secret |
<IP address> key | between the switch and the RADIUS server(s). |
| Command mode: Global configuration |
|
|
[no] | Sets the secondary RADIUS server address and shared secret |
<IP address> key | between the switch and the RADIUS server(s). |
| Command mode: Global configuration |
|
|
Enter the number of the User Datagram Protocol (UDP) port to be | |
number> | configured, between |
| Command mode: Global configuration |
|
|
| Sets the number of failed authentication requests before switching |
| to a different RADIUS server. The range is |
| default is 3 requests. |
| Command mode: Global configuration |
|
|
| Sets the amount of time, in seconds, before a RADIUS server |
| authentication attempt is considered to have failed. The range is |
| |
| Command mode: Global configuration |
|
|
[no] | Enables or disables the RADIUS back door for |
| telnet/SSH/HTTP/HTTPS. This command does not apply when |
| secure backdoor is enabled. |
| Command mode: Global configuration |
|
|
[no] | Enables or disables the RADIUS back door using secure password |
| for telnet/SSH/HTTP/HTTPS. This command does not apply when |
| backdoor (telnet) is enabled. |
| Command mode: Global configuration |
|
|
Enables the RADIUS server. | |
| Command mode: Global configuration |
|
|
106