HP 445942-001 manual Viewing and saving changes, Saving the configuration

Configuration Commands

Configuration Commands

Introduction

The Configuration commands are available only from an administrator login. They include commands for configuring every aspect of the HP 10GbE switch . Changes can be saved to non-volatile memory (NVRAM).

The following table describes the basic Configuration commands. The following sections provide more detailed information and commands.

Table 75 Configuration commands

Command	Usage
show running-config	Dumps current configuration to a script file.
	Command mode: All
copy running-config {ftptftp}	Backs up current configuration to FTP/TFTP server.
	Command mode: All
copy {ftptftp} running-config	Restores current configuration from FTP/TFTP server.
	Command mode: All

Viewing and saving changes

As you use the configuration commands to set switch parameters, the changes you make take effect immediately. You do not need to apply configuration changes when you use the ISCLI. Any changes are lost the next time the switch boots unless the changes are explicitly saved.

Saving the configuration

You must save configuration changes to flash memory, so the switch reloads the setting when you reset the switch.

IMPORTANT: If you do not save the changes, they are lost the next time the system is reloaded.

To save the new configuration, enter the following command at any prompt:

Switch# copy running-config startup-config

When you save configuration changes, the changes are saved to the active configuration block.

For instructions about selecting the configuration to run at the next system reload, see the “Selecting a configuration block” section in the “Boot Options” chapter.

101