
Configuration Commands
Port-based port mirroring
The following table describes the
Table 171 Port Mirroring Configuration commands
Command | Description | |
|
| |
Adds the port to be mirrored. This command also allows you to enter | ||
<port number> | the direction of the traffic. It is necessary to specify the direction | |
<port number> {inoutboth} | because: | |
| ||
| • If the source port of the frame matches the mirrored port and the | |
| mirrored direction is ingress or both (ingress and egress), the frame | |
| is sent to the mirrored port. | |
| • If the destination port of the frame matches the mirrored port and | |
| the mirrored direction is egress or both, the frame is sent to the | |
| monitoring port. | |
| Command mode: Global configuration | |
|
| |
no | Removes the mirrored port. | |
<port number> | Command mode: Global configuration | |
<port number> | ||
| ||
|
| |
no | Deletes this monitor port. | |
<port number> | Command mode: Global configuration | |
| ||
|
| |
show | Displays the current settings of the monitoring port. | |
| Command mode: All except User EXEC | |
|
|
Uplink Failure Detection configuration
Uplink Failure Detection (UFD) supports network fault tolerance in network adapter teams. Use these commands to configure a Failure Detection Pair of one Links to Monitor (LtM) group and one Links to Disable (LtD) group. When UFD is enabled and a Failure Detection Pair is configured, the switch automatically disables ports in the LtD if it detects a failure in the LtM. The failure conditions which are monitored in the LtM group include port link state moving to down, or port state moving to Blocking if Spanning Tree Protocol is enabled.
The following table describes the Uplink Failure Detection (UFD) Configuration commands. Table 172 Uplink Failure Detection Configuration commands
Command | Description |
|
|
ufd enable | Globally turns Uplink Failure Detection ON. |
| Command mode: Global configuration |
|
|
no ufd enable | Globally turns Uplink Failure Detection OFF. |
| Command mode: Global configuration |
|
|
show ufd | Displays the current Uplink Failure Detection configuration parameters. |
| Command mode: All |
|
|
182