Statistics Commands
Statistics Commands
Introduction
You can view switch performance statistics in the user, operator, and administrator command modes. This chapter discusses how to use the ISCLI to display switch statistics.
The following table describes general Statistics commands. Table 44 Statistics commands
Command | Usage |
|
|
show layer3 counters | Displays Layer 3 Statistics. |
| Command mode: All |
|
|
show | Displays SNMP statistics. |
| Command mode: All |
|
|
show ntp counters | Displays Network Time Protocol (NTP) Statistics. |
| You can execute the clear command option to delete all statistics. |
| Command mode: All |
|
|
clear ntp | Clears Network Time Protocol (NTP) Statistics. |
| Command mode: All |
|
|
show ufd counters | Displays Uplink Failure Detection statistics. |
| Command mode: All |
|
|
show counters | Dumps all switch statistics. Use this command to gather data for tuning and |
| debugging switch performance. If you want to capture dump data to a file, |
| set your communication software on your workstation to capture session |
| data prior to issuing the dump command. |
| Command mode: All |
|
|
67