HP 445942-001 manual Layer 2 configuration, 802.1x configuration, Vlan

Configuration Commands

Layer 2 configuration

The following table describes the Layer 2 Configuration commands. The following sections provide more detailed information and commands.

Table 100 Layer 2 Configuration commands

Command	Description
vlan {<1-4094>}	Enter VLAN configuration mode.
	Command mode: Global configuration
[no] spanning-tree uplinkfast	Enables or disables Fast Uplink Convergence, which provides rapid
	Spanning Tree convergence to an upstream switch during failover.
	NOTE: When enabled, this feature increases bridge priorities to 65500
	for all STGs and path cost by 3000 for all external STP ports.
	Command mode: Global configuration
spanning-tree uplinkfast max-	Configures the station update rate, in packets per second.
update-rate <10-200>	The range is 10-200. The default value is 40.
	Command mode: Global configuration
show layer2	Displays current Layer 2 parameters.
	Command mode: All

802.1x configuration

This feature allows you to configure the HP 10GbE switch as an IEEE 802.1x Authenticator, to provide port-based network access control. The following table describes the 802.1x Configuration commands.

Table 101 802.1x Configuration commands

Command	Description
dot1x enable	Globally enables 802.1x.
	Command mode: Global configuration
no dot1x enable	Globally disables 802.1x.
	Command mode: Global configuration
show dot1x	Displays current 802.1x parameters.
	Command mode: All

126