HP 445942-001 manual ACL IP Version 4 Filter configuration, IP mask

	Configuration Commands
Table 156 Ethernet Filter Configuration commands
Command	Description
access-control list <1-384> ethernet	Defines the Ethernet type for this ACL.
ethernet-type {ARPIPIPv6MPLS	Command mode: Global configuration
RARPany0xXXXX}
access-control list <1-384> ethernet	Defines the Ethernet priority value for the ACL.
priority <0-7>	Command mode: Global configuration
default access-control list <1-384>	Resets Ethernet parameters for the ACL to their default values.
ethernet	Command mode: Global configuration
show access-control list {<1-384>}	Displays the current Ethernet parameters for the ACL.
ethernet	Command mode: All except User EXEC

ACL IP Version 4 Filter configuration

These commands allow you to define IPv4 matching criteria for an ACL. The following table describes the IP version 4 Filter Configuration commands.

Table 157 IPv4 Filter Configuration commands

Command	Description
access-control list <1-384> ipv4	Defines a source IP address for the ACL. If defined, traffic with this
source-ip-address <IP address>	source IP address will match this ACL. Specify an IP address in
{<IP mask>}	dotted decimal notation.
	Command mode: Global configuration
access-control list <1-384> ipv4	Defines a destination IP address for the ACL. If defined, traffic
destination-ip-address <IP	with this destination IP address will match this ACL.
address> {<IP mask>}	Command mode: Global configuration
access-control list <1-384> ipv4	Defines an IP protocol for the ACL. If defined, traffic from the
protocol <0-255>	specified protocol matches this filter. Specify the protocol number.
	Some of the well-known protocols include:
	1—icmp
	2—igmp
	6—tcp
	17—udp
	89—ospf
	112—vrrp
	Command mode: Global configuration
access-control list <1-384> ipv4	Defines a Type of Service value for the ACL. For more information
type-of-service <0-255>	on ToS, see RFC 1340 and 1349.
	Command mode: Global configuration
default access-control list <1-	Resets the IPv4 parameters for the ACL to their default values.
384> ipv4	Command mode: Global configuration
show access-control list <1-384>	Displays the current IPV4 parameters.
ipv4	Command mode: All except User EXEC
	172