Information Commands

Show all FDB information

The following command displays Forwarding Database information: show mac-address-table

Command mode: All

MAC address

VLAN

Port

Trnk

State

-----------------

----

----

----

-----

00:02:01:00:00:00

300

 

1

TRK

00:02:01:00:00:01

300

20

 

FWD

00:02:01:00:00:02

300

20

 

FWD

00:02:01:00:00:03

300

20

 

FWD

00:02:01:00:00:04

300

20

 

FWD

00:02:01:00:00:05

300

20

 

FWD

00:02:01:00:00:06

300

20

 

FWD

00:02:01:00:00:07

300

20

 

FWD

00:02:01:00:00:08

300

20

 

FWD

00:02:01:00:00:09

300

20

 

FWD

00:02:01:00:00:0a

300

20

 

FWD

00:02:01:00:00:0b

300

20

 

FWD

00:02:01:00:00:0c

300

20

 

FWD

An address that is in the forwarding (FWD) state indicates that the switch has learned it. When in the trunking (TRK) state, the Trnk field displays the trunk group number. If the state for the port is listed as unknown (UNK), the MAC address has not yet been learned by the switch, but has only been seen as a destination address. When an address is in the unknown state, no outbound port is indicated.

Clearing entries from the forwarding database

To delete a static MAC address from the forwarding database (FDB), see the “Static FDB configuration” section in the “Configuration Commands” chapter.

Link Aggregation Control Protocol information

The following table describes the Link Aggregation Control Protocol information commands. Table 20 LACP information commands

Command

Usage

 

 

show interface port <port number> lacp aggregator

show lacp

show lacp information

Displays LACP aggregator information for the port. Command mode: All

Displays LACP information for the port. Command mode: All

Displays all LACP information parameters. Command mode: All

33

Page 33
Image 33
HP 445942-001 manual Link Aggregation Control Protocol information, Show all FDB information