HP 445942-001 manual IP Forwarding configuration, Network Filter configuration, IP netmask

Configuration Commands

IP Forwarding configuration

The following table describes the IP Forwarding Configuration commands.

Table 124 IP Forwarding Configuration commands

Command	Description
[no] ip routing direct-broadcasts	Enables or disables forwarding directed broadcasts. This
	command is disabled by default.
	Command mode: Global configuration
ip routing	Enables IP forwarding (routing) on the switch.
	Command mode: Global configuration
no ip routing	Disables IP forwarding (routing) on the switch. Forwarding is
	turned off by default.
	Command mode: Global configuration
show ip routing	Displays the current IP forwarding settings.
	Command mode: All except User EXEC

Network Filter configuration

The following table describes the Network Filter Configuration commands.

Table 125 Network Filter Configuration commands

Command	Description
	Sets the starting IP address the IP subnet mask for this filter.
ip match-address <1-256> <IP address>
<IP netmask>	The default address is 0.0.0.0.
	This command defines the range of IP addresses that will be
	accepted by the peer when the filter is enabled.
	Command mode: Global configuration
ip match-address <1-256> enable	Enables the Network Filter configuration.
	Command mode: Global configuration
no ip match-address <1-256> enable	Disables the Network Filter configuration.
	Command mode: Global configuration
no ip match-address <1-256>	Deletes the Network Filter configuration.
	Command mode: Global configuration
show ip match-address [<1-256>]	Displays the current the Network Filter configuration.
	Command mode: All except User EXEC

146